ANALYSIS OF THE COST IMPACT AT THE XYZ COMPANY DUE TO FUEL CONVERSION FROM COMPRESSED NATURAL GAS (CNG) TO INDUSTRIAL DIESEL OIL (IDO) FOR POWERING A HOT-GAS GENERATOR
Abstract
PT. XYZ pursues the efficiency of the mill machine by the fuel convertion. Here, the fuel is to power the hot gas of the cement mill machine. Thus, the effect of those detected by the exit temperature machine. The method of investigation to the using of different fuels are Industrial Diesel Oil (IDO) and Compressed Natural Gas CNG experimentally. The hot gas effect observed by the exit temperature of the cement mill machine. The boiler performance is monthly average running. The IDO performs in May, and CNG is in September. Experimental method deploys a seven-week trial procedure. The exit temperature of the cement mill is studied by monitoring it’s fluctuate. Further, the economical balance present the fuels used counted by its operational cost. The result of the exit temperature of cement mill machine is 91ºC for IDO use. It is higher than the operation average temperature of about 87ºC. It rises 10% better than that in CNG. The machine efficiency revises 15%. The operation cost depresses to 18.98% per year. It is about Rp 1,972,718.106 from Rp 10,393,667.576 per year. Otherwise, the exit temperature of mill machine is a reference to obtain the machine’s high reliability
Downloads
References
N. A. Madlool, “Assessment of waste preheater gas and dust bypass systems: Al-Muthanna cement plant case study,” Case Study. Therm. Eng., vol. 8, pp. 330–336, 2016, doi: 10.1016/j.csite.2016.09.003.
A. Husen, “Analisis Efisiensi Energi Pada Boiler Industri Tipe Fire-Tube Kapasitas 2 Ton/Jam Dengan Bahan Bakar Compressed Natural Gas (CNG) Di Pt.X,” Sainstech J. Penelit. Dan Pengkaji. Sains Dan Teknol., vol. 32, no. 2, pp. 67–75, 2022, doi: 10.37277/stch.v32i2.1302.
G. P. A. Gumelar, M. N. Dewi, A. Miftah, W. Endranaka, and B. A. F. Eka, “Analisis Efisiensi Boiler Berbahan Bakar Gas di PT XYZ Menggunakan Metode Langsung dan Tidak Langsung,” Technol. Renew. Energy Dev., vol. 2, no. 1, pp. 22–28, 2022.
F. Ainun and J. Jamaaluddin, “Analisa Efisiensi Economizer Terhadap Boiler (Gas Dan Solar) Di PT. Spindo III, Tbk,” JEEE-U (Journal Electr. Electron. Eng., vol. 2, no. 2, pp. 99–104, 2018, doi: 10.21070/jeee-u.v2i2.1697.
T. Hernawati, M. Arfah, and M. A. Rianto, “Analisa Prioritas Bahan Baku untuk Bahan Bakar Boiler Menggunakan Metode Analytical Hierarchy Process di PT Sago Nauli,” Semnastek Uisu, pp. 263–266, 2023, https://jurnal.uisu.ac.id/index.php/semnastek/article/view/7293.
Nahda Alifa Zahira Putri, Ika Yuliani, and Sri Widarti, “Pengaruh Pemakaian Jenis Bahan Bakar Terhadap Kinerja Boiler dengan Metode Langsung dan Tidak Langsung,” J. Surya Tek., vol. 11, no. 1, pp. 349–356, 2024, doi: 10.37859/jst.v11i1.7324.
S. Harnowo and Y. Yunaidi, “Kinerja Boiler dengan Sistem Pembakaran Bersama antara Ampas Tebu dengan Sekam Padi dan Cangkang Kelapa Sawit,” Semesta Tek., vol. 24, no. 2, pp. 102–110, 2021, doi: 10.18196/st.v24i2.12937.
S.B. Sasongko et al., “Pengaruh Variasi Komposisi Octane Booster Dan Bahan Bakar Terhadap Performance Dan Gas Buang Pada Sepeda Motor 4 Tak,” Prosiding Senastitan IV, pp. 4–8, 2024, https://ejurnal.itats.ac.id/senastitan/article/view/5658.
S. Sasongko, T. Arlisa, and H. Irawan, “Perbaikan Performa Mesin Automatic Vehicle Dengan Fuel-Booster Racing,” Otopro, vol. 19, no. 1, pp. 18–23, 2023, doi: 10.26740/otopro.v19n1.p18-23.
P. Priyanto and S. Wilastari, “Faktor-Faktor Penyebab Menurunnya Kinerja Boiler Di PT. Papertech Indonesia,” Maj. Ilm. Gema Marit., vol. 24, no. 1, pp. 60–66, 2022, doi: 10.37612/gema-maritim.v24i1.281.
F. G. Sumarno and B. Prasetiyo, “Analisis Kinerja Efisiensi Economizer Terhadap Pemakaian Bahan Bakar Boiler Di PLTU Tanjung Jati B Unit 4," EKSERGI J. Teknik Energi, vol. 14, no. 2, pp. 36-39, 2018, doi: http://dx.doi.org/10.32497/eksergi.v14i2.
G.L. Hakim, H. Rahman, and A. Akbar, “Analisis Kebutuhan Air Pendingin pada Gas Conditioning Tower (GCT) Raw Mill,” Semin. Nas. TREnD, pp. 104–111, 2021, https://jurnalftijayabaya.ac.id/index.php/TREnD/article/view/103.
K. Ridwan and Tahdid, “Studi Efisiensi Termal Ketel Uap dengan Melihat Pengaruh Rasio Udara-Bahan Bakar Solar Pada Alat Water Tube Boiler,” Kinetika, vol. 1, no. 1, p. 355918, 2011, https://jurnalftijayabaya.ac.id/index.php/TREnD/issue/view/10.
R. Puspita et al., “Evaluasi Kinerja Alat Mill Fan Di Cement Mill Pada PT Semen Baturaja Persero Tbk . Pada unit cement mill 05 di PT. Semen Baturaja secara garis A. Vertical Cement Mill,” J.Mult. Bhara., vol. 1, no.3, pp. 462−476, 2022, doi: https://doi.org/10.62668/jimr.v1i02.494.
A.M.A. Abid and F. Ashari, “Menentukan Penjadwalan Maintenance Mesin Finish Mill Dengan Metode FMEA Di PT Semen Indonesia (PERSERO) Tbk,” J. Teknol. dan Manaj. Sist. Ind., vol. 1, no. 2, pp. 77–84, 2022, doi: 10.56071/jtmsi.v1i2.435.
Copyright (c) 2025 Sukendro Broto Sasongko, Rochmad Edy Budi Laksono, Hery Irawan
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
